BC-3500 Bill and Coin Changer
3-18 25238801
2. Adjust the lower bill box stop bracket and mounting plate so that the bottom bill box is aligned with the upper
bill box and chute guides by:
A. Loosen the two 8-32 screws (A) holding the mounting plate (C) to the stacker.
B. Loosen the two screws (B) holding the mounting plate to the cabinet.
C. Move the mounting plate around until proper alignment is obtained.
D. Tighten all four screws.
3. Refer to Figure 3-16 and make sure that the bill boxes are tight against the chute guides (A) to get proper
stacking.
4. Refer to Figure 3-17 and loosen the two #8-32 screws (A) in the lower bill box stop bracket (D). Push the
lower box tight against the chute guides. Push the lower bill box stop bracket tight against the bill box and tighten
the two #8-32 screws.
5. Check that the spring wire (B) on the top door is properly positioned by leaving the upper bill box unlatched
(let the bill box stick out approximately 2½ inches).
6. Slowly close the top door and verify that the spring wire pushes the upper bill box into the latched position (see
Figure 3-17).
To Next Page
