Alpha 600/601 User’s Guide 13
About the Displays
Operator Display
Your cash register also has a 2 line display for the operator. Both lines
shows letters and numbers (alphanumeric). The following codes can
appear in the display:
Table 2 Codes and words that can appear in the display
This code... Appears when...
: the -%/RA key registers a percent discount amount. Also appears
in the Customer Display.
= the Charge, Check, Amount Tend Total keys are pressed. Also
appears in the Customer Display.
ADD ON the +%/PO key registers a plus percentage amount. *
CASH the Amount Tend Total key finalizes a cash sale. *
CHANGE or C change is due. *
CHARGE the Charge key finalizes a sale. *
CHECK the Check key finalizes a sale. *
CLERK ERR or
CLERK E12
clerk numbers have been programmed and the clerk system is
active. When this appears, the clerk number must be entered.
COUPON the -/CPN key is pressed. *
DISCOUNT the -%/RA key registers a percent discount amount. *
E.J FULL the Electronic Journal memory is full. Run the electronic journal
report to clear the memory. See EJ -FULL Error on page 100.
ERROR an incorrect key is pressed. Press the Clear key to clear.
NO SALE the #/ST/NS key is pressed. *
NON TAX the Non Tax key is pressed.
P you are in the middle of a programming step. Also appears in the
Customer Display.
PE if an error is detected in the printer.
PAPER END there may be a printer error.
P-O the +%/PO key is used for a paid out function. *
R-A the -%/RA key is used for a received on account function. *
REFUND the Return key is pressed. *
SEC CODE a manager password is programmed. When this appears, you
must enter the password.
SUBTTL the Subtotal w/Tax or #ST/NS key is pressed. *
TAX 1/TAX 2 the TAX 1 or TAX 2 key is pressed.
VOID/CORR the Void key is operated. *
* also prints on the receipt or journal tape.
To Next Page
Loading...
