Royal 601sc - Setting the Sales Message Start and Stop Times; Setting the Idle Messages Start Time

Alpha 600/601 User’s Guide 53
Programming Scrolling Message Display Times
Setting the Sales Message Start and Stop Times
To program the Sales message start time setting
1 Put the PRG key in the Mode key slot and turn it to the PRG position.
2 If you are prompted for a Manager Password, type the password number
and then press the Check key. If you did not program a Manager
Password, go to the next step.
3 Using the round Number keys, press 3, press the number of seconds you
want to delay as 2 digits, and press the Charge key.
To program the Sales message stop time setting
1 Put the PRG key in the Mode key slot and turn it to the PRG position.
2 If you are prompted for a Manager Password, type the password number
and then press the Check key. If you did not program a Manager
Password, go to the next step.
3 Using the round Number keys, press 4, press the number of seconds
you want to delay as 2 digits, and press the Charge key.
Setting the Idle Messages Start Time
SALES message
start
Number of seconds after a sale is
complete before the message
starts.
The register must be set in REG
mode.
Settings in
seconds: 00 – 99
Default=10
SALES message
stop
Number of seconds the Sales
message runs before the Idle
message starts.
The register must be set in REG
mode.
Settings in
seconds: 00 – 99
Default=20
00 = No Sales
message appears
Idle message
display after the
time appears
Number of seconds for the Time
to appear before the Idle
message appears again.
When the Time changes while an
Idle message is running, the time
appears for a few seconds. After
the specified time, the Idle
message appears again.
Settings in
seconds: 0 – 9
0 does not show
the time at all.
Default=5