Chapter 6: Ringing up Sales and Using Training Mode
74 Alpha 600/601 User’s Guide
• Automatic Receipt Print - Using REG1 mode, the sales receipt will print
automatically for every transaction. You can print a duplicate copy of
the previously printed customer receipt if one is necessary.
Put the REG key in the Mode key slot, turn it to the REG1 position, and
complete the sales transaction. Before you start the next transaction or
any other function, press the Amount Tend Total key for a duplicate
copy of the customer receipt.
• Receipt on Demand - Using REG2 mode, a customer receipt is not
printed automatically, but can be printed by manually requesting one.
When REG2 mode is used with the printer turned off, this allows you to
conserve receipt paper when the customer receipts are not required for
every transaction.
Put the REG key in the Mode key slot, turn it to the REG2 position, and
complete the sales transaction. Before you start the next transaction or
any other function, press the Amount Tend Total key for a print-out of
the customer receipt.
To use the Receipt on Demand feature, make sure the Flag options for
Flag #21 and 34 are both set to the factory default setting of 1.
Flag #21 0 = REG2 mode set to Print mode.
1* = REG2 mode set to Non-print mode. Customer receipts
are not printed automatically during a sales transaction.
Flag #34 0 = Disable printing of duplicate receipts
1* = Allow printing of a duplicate receipt for previous
transaction
To Next Page
Loading...
