2323
The following data can be configured:
n Name Tag This is the alarm name which uniquely identies the alarm.
n HI Description Tag This is the alarm fault condition if Active HI is selected. If Active LOW is selected
the normal condition description of the alarm is entered.
n HI SMS Tick Box Tick this box if an SMS is required when this alarm condition is activated.
n LO Description Tag This is the alarm fault condition if Active LOW is selected. If Active HI is selected
the normal condition description of the alarm is entered.
n LO SMS Tick Box Tick this box if an SMS is required when this alarm condition is activated.
n Alarm Message for LCD Enter the alarm condition description for the LCD.
n Active HI/LOW Select the Active HI alarm condition for Dry Contacts which are normally closed,
activating the alarm when open. Select Active LOW alarm condition for Dry
Contacts which are normally open, activating the alarm when closed.
n Enable/Disable Three selection options are available:
1 = Enable Notication of alarm will be made on the LCD and SMS
if selected.
0 = Disable Notication of alarm is disabled. The daily Disabled Alarms
report will include all disabled alarms.
P = Permanently Disabled Notication of alarm is disabled and is not
included in the Disabled Alarms report.
Select Save to store data on the unit after all elds have been congured. Select Cancel and follow the prompted instructions to revert
back to the previous settings. The data will not be stored in this case.
To Next Page
Loading...
Need help?
General