RT Systems TM3 User Manual

3
document overview
The TM3 Unit Installation and Users Manual describes how to install a TM3 Monitoring Unit, how sensors are connected and conguration
of the sensor inputs is performed. It also describes maintenance and fault nding. After performing the installation and conguration
procedures as set out in this document, the TM3 Unit is ready for installation specic conguration and operational environmental
monitoring.
product certification
The TM3 Unit CE certication is pending. The following IEC specications are applicable to the TM3 Monitoring Unit:
n Electrical Fast Transients (EFT) IEC 61000-4-4
n Electrostatic Discharge (ESD) IEC 61000-4-2
n Surges IEC 61000-4-5
n Radiated Susceptibility IEC 801-3
n Voltage Dips and Interruptions IEC 61000-4-11
n Conducted Susceptibility IEC 61000-4-6
n Emissions and Harmonics IEC 61000-3-3 and IEC 61000-3-2
n General Products Safety Directive 2001/95/EC
n RoHS Compliance 2002/95/EC
related documents
Unless otherwise noted, the following documentation and software is available on the CD provided with the device or on the applicable
product page on the RT Systems website www.rtsystems.co.za
n Installation and Users Manual
n ICASA Approval Certicate
n GSM Module Certication Data
n IP Set Software
n IOD’s
n TM3 Base Station Programming Software.
Refer to the software help le for installation and users instructions.
n SD card default conguration les
n SNMP mib le

RT Systems TM3 Specifications

General

Brand	RT Systems
Model	TM3
Category	Measuring Instruments
Language	English