40
self test
By selecting the Self Test key, the unit performs a sequence of tests to determine its own health status. While the test is in progress, the
following screen will be displayed:
Once the self test has been completed, a message will be displayed indicating whether the test has been successful or not. In the event
of the test being successful, a “Self Test Pass” message appears on the LCD, else a “Self Test Fail” message will be displayed along
with a relevant message indicating the area of failure which can be one of the following:
n GSM Card Fault
n Ethernet Fault. Ethernet functionality will only be tested if the “Transmit alarms to e-mail” is ticked in the Ethernet/Internet
Conguration page
n Power Supply Fault
To Next Page
Loading...