3939
front panel functions
On the front panel of the TM3 Monitoring Unit there are a couple of functions available to either congure the unit or select a particular
function. The functions available are the following:
n TEMP Congure the temperature sensor thresholds and calibration data.
n SELF TEST Performs a self test of the unit.
n Disable/Enable All Alarms Disables or enables all alarms.
n Clock Set the time and date of the unit.
n Enter Displays raw input data for installation/fault nding purposes.
temp
To set a sensor’s temperature thresholds press the “Temp” key on the front panel of the unit.
Select the sensor to be congured by pressing “Temp” until the correct sensor number is displayed. Then press “Enter” to display the
current sensor threshold values.
The data available for conguration is “Non-Critical” and “Critical”. Use the Right and Left keys to move the cursor to the data eld which
has to be adjusted. By pressing the Up or Down key the data eld will be incremented or decremented. After all data elds have been
adjusted to the required values, press the Enter key to store the data.
A “Thresholds Stored” message will appear briey while the data is being stored.
To Next Page
Loading...
Need help?
General