To Next Page

To Previous Page

Chapter 5 • TheaterTouch Designer Advanced Features

IRF-6 TAB

The

IRF-6

tab options are:

IR Outputs

group box:

Check the box(s) that corresponds with the output(s) you wish to send the

commands on this button out of the IRF-6. Note that the labels for the output

can be changed with the

Edit Remote Properties

command on the

Edit

menu.

The default is to have the commands come out of all of the outputs on the

IRF-6. This option will not normally need to be changed unless you have

multiple identical components or are using one of the power sensor modules.

Send this code

group box:

The options in this section require that a power sensor module be plugged into

the appropriate port on the IRF-6.

Always -

Check this option to send the IR code regardless of the power sensor

state. This option should also be checked if no power sensor is connected to

the selected IR output.

Only when device is ON -

Check this option to send the IR code only if the

power sensor in the specified port detects that the equipment it is monitoring

is ON.

Only when device is OFF -

Check this option to send the IR code only if the

power sensor in the specified port detects that the equipment it is monitoring

is OFF.

Note:

In order to use the power sensor options, exactly one

IR output

must be selected in the IRF-6 Output box, and the power sensor must be

plugged into that

IR output port.

RTI TheaterTouch T2 User Manual

Questions and Answers: