s::can con::cube D-330 - 2 Safety Guidelines; 2.1 Declaration of Conformity; 2.2 Special Hazard Warning

2 Safety Guidelines
Installation, electrical connection, initial startup, operation and maintenance of any s::can product as well as complete
s::canmeasuring systems must only be performed by qualied personnel.Thisqualiedpersonnel has to be trained and
authorisedbytheplantoperatororbys::canfortheseactivities.Thequaliedpersonnelmusthavereadandunderstoodthis
manual and have to follow the instructions contained in this manual.
For proper initial startup of complete s::can measuring systems, the manuals for the controller and software used for operation
(e.g. con::lyte, con::cube, con::nect, moni::tool), the connected probes and sensors as well as the used additional devices (e.g.
compressor) have to be consulted.
The operator has to obtain the local operating permits and has to comply with the joint constraints associated with these.
Additionally, the local legal requirements have to be observed (e.g. regarding safety of personnel and means of labour,
disposal of products and materials, cleaning, environmental constraints). Before putting the measuring device into operation,
the operator has to ensure that during mounting and initial startup - in case they are executed by the operator himself - the
local legislation and requirements (e.g. regarding electrical connection) are observed.
All s::can products are leaving our factory in immaculate technical and safety conditions. Inappropriate or not intended use of
the product, however, can cause danger! The manufacturer is not responsible for damage caused by incorrect or unauthorised
use. Any kind of manipulation of the instrument is strictly prohibited - except for the activities described in this document.
Conversions and changes to the device must not be made, otherwise all certications and guarantee / warranty become
invalid. For details regarding guarantee and warranty please refer to our general conditions of business.
2.1 Declaration of Conformity
This s::can product has been developed, tested and manufactured for electromagnetic compatibility (EMC) and according to
applicableEuropeanstandards,asdenedinthedeclarationofconformity.
CE-marks are applied on the device. The declaration of conformity related to this marking can be requested from s::can or your
local s::can sales partner or can be downloaded from the s::can Customer Portal.
2.2 Special Hazard Warning
Because the s::can measuring systems are frequently installed in industrial and communal waste water applications,
one has to take care during mounting and demounting of the system, as parts of the device can be contaminated
with dangerous chemicals or pathogenic germs. All necessary precautions should be taken to prevent endangering of
one’s health during work with the measuring device.
!
con::cube D-330, 01-2020 Release Copyright © s::can Messtechnik GmbH
www.s-can.at6 / 42
!