Safe Fleet DH4C - Network Settings

© Safe Fleet | 2020 | All rights reserved | Part #: 700-1213 R1
DH4C Installation Guide
p. 36
DH4C Advanced Conguration
Network Settings
 Note: Conguring Network Settings and Advanced Network settings
• Each host (computer) connected to the network must have a unique IP address.
• If the IP information is changed and saved in a conguration le for upload to other DVRs, their settings must also
be updated. For more information, see DH4C Conguration: Copying DVR Conguration.
Contact Safe Fleet Engineering Services or Technical Support to assign an IP address or reset the Smart-Reach Mobile
wireless bridge, or for more information.
To congure Network Settings:
1. Select Network to open the tab.
2. Congure settings as required. For details, see Menu
Options, below.
3. Click Back to save settings and return to the Conguration
menu.
 Note: Conguring WIFI
• If the DVR's built-in WIFI is used, see "Built-in WIFI Settings" on page 39.
• If the DVR is attached to an external WIFI bridge, update the Network Settings tab with information supplied by the
system administrator, as shown below.
 Caution: Qualied personnel only
A qualied IT administrator is required to provide information and congure Network Settings and Advanced Net-
work settings.
These tasks should only be performed by Safe Fleet Engineering services or the eet system administrator.