Safe Fleet DH4C - Advanced Network Settings

© Safe Fleet | 2020 | All rights reserved | Part #: 700-1213 R1
DH4C Installation Guide
p. 37
DH4C Advanced Conguration
ITEM DESCRIPTION VALUE [DEFAULT]
Setting
Type
Contact your administrator to congure the setting type and IP address.
OFF disables all Ethernet capability.
Static IP is a permanent address on the network, assigned by the
network administrator. DHCP (Dynamic Host Conguration Protocol)
automates the assignment of IP addresses in a network.
If DHCP is used, the subnet mask, default gateway, and DNS server are
congured automatically, and only the HTTP Port eld is editable.
[Static IP], OFF, DHCP
IP Address Enter the DVR IP Address, as determined by a qualied network expert. [169.254.1.1]
Subnet
Mask
Enter the Subnet Mask, as determined by a qualied network expert. [255.255.0.0]
LAN
Gateway
Gateway address uniquely identies a host or computer on the LAN,
which connects the subnet to other networks. Enter the LAN Gateway,
as determined by a qualied network expert.
[169.254.1.1]
DNS Server Uses an IP address composed of four octets, separated by decimals. [0,0,0,0]
MAC
Address
MAC (Media Access Control) is the DVR's unique hardware number. Fixed
HTTP Port Typically, leave the HTTP Port set to 80, unless otherwise instructed by
IT personnel.
80
Menu Options
Advanced Network Settings
Conguring Advanced Settings
Use the Advanced Settings (vMax Live Plus) tab to set up the DVR to connect with vMax Live Plus via a cellular modem. For
more information, see the vMax Live Plus documentation available on Safe Fleet Community.
 Qualied IT Administrator Required
A qualied IT administrator is required to perform network conguration, including assignment of IP addresses.
A cellular modem or gateway must also be installed and congured.
Contact Safe Fleet Engineering Services or Technical Support for more information.