Sagem D30V User Manual

35
ACCESSORIES
Monitoring a room
Two handsets must be registred on the same
base to use this function. You can use your
handset to monitor a room. This allows you,
for example, to monitor a baby's room.
To do so, place one of the handsets in the
room to be monitored. This unit will be in
"sender" mode.
The other handset will remain with you, it is in
"receiver" mode.
On the receiver handset:
On the navigator key , press  or 
until the ACCESSORIES screen is
displayed, press OK to confirm.
Select ROOM MONITOR. using  or .
Press Valid. .
Select the sender handset using  or .
Press Call .
The sender handset rings, pick up using the
green key .
On the transmitter handset:
A screen invites you to activate the monitor
mode (sender mode). Press Yes .
Both handsets are now in monitor mode.
• Place the sender handset in the room to
be monitored.
The handset in sender mode does
not ring to notify you of incoming
calls. It can therefore be placed in a
room where someone is sleeping.
• Keep the receiver handset with you.
To stop monitoring:
-Press Stop on the transmitter set. The
receiver set will automatically return to the
standby screen.
-Press Stop on the receiver set and
confirm by pressing Yes and Stop
on the transmitter handset at the same
time.
When in monitor mode, the receiver
handset can be used to make calls.
To make a call: press Call and
dial the number.
To answer a call: press green
key .
At the end of the call, the handset
will automatically return in monitor
mode.
LU 252973993 D30 T V H Australie.book Page 35 Mercredi, 20. juin 2007 9:47 09

Sagem D30V Specifications

General

Brand	Sagem
Model	D30V
Category	Cordless Telephone
Language	English