Sagem D30V User Manual

46
SETTINGS
BASE SETTINGS
Using a handset to put the base
in registration mode
This function enables you to put the base in
registration mode so you can register a new
handset. To do so, the handset to be
registered must be in registration mode (refer
to paragraph Registering a new handset to
a base, page 43).
On the navigator key , press  or 
until the SETTINGS screen is displayed,
press OK to confirm.
Select ADVANCED SET. using  or .
Press Valid. .
Select SET BASE using  or . Press
Valid. .
Select REGISTR. MODE using  or .
Press Valid. .
A screen prompts you to confirm the setting
of the base to the registration mode. Press
Yes to enter the registration mode. The
indicator light on your base starts to quickly
blink green.
Your base will remain in registration mode for
about 1 minute.
Resetting the base
When you reset your base, all the base
parameters are reset to their initial values
(factory settings), your SMS are not deleted.
On the navigator key , press  or 
until the SETTINGS screen is displayed,
press OK to confirm.
Select ADVANCED SET.. Press Valid. .
Select SET BASE. Press Valid. .
Select RESET BASE using  or . Press
Valid. .
A confirmation screen will prompt you to
confirm your request:
• To reset the base, press Yes .
• If you do not wish to reset the base,
press No .
Enter the base code. Press Valid. . The
RE-INIT. IN PROCESS message is
displayed on the screen.
To exit the menu, press the red key .
You can also put the base in
registration mode :
• For the D30T, press on the
button on the base for a
few seconds.
• For the D30V, press on the
button on the base for a few
seconds.
LU 252973993 D30 T V H Australie.book Page 46 Mercredi, 20. juin 2007 9:47 09

Sagem D30V Specifications

General

Brand	Sagem
Model	D30V
Category	Cordless Telephone
Language	English