Sagem SAGEM-LINK F - Page 31

SAGEM-LINK F 288055571-04
Installation and Operation Manual
Page 31/142
Issue 04 : July 2005
Reproduction and communication prohibited without the written permission of Sagem Communication
9600 bit/s Auxiliary Data Channel (AUX1 & Aux2)
The 9600 bit/s auxiliary data channels "AUX1" and AUX2 are connected to two DB 9 connectors on
the rear panel.
This data channels can be configured either in a DCE V11 interface, or V28 interface (compliant to
EIA 574 standard). Depending on the interface, connector pinout is given on Figure 1.25
15
96
Pin # V11 Interface V28 Interface
1 Ground Ground
6NC NC
2 Output Data – (+) Output Data
7 Output Data – (-) NC
3 Input Data – (+) Input Data
8 Input Data – (-) NC
4NC NC
9NC NC
5 Ground Ground
Figure 1.25 – Aux1 or Aux2 Data Channel Connector Pinout
Serial Management Interface Ports MGMT1 and MGMT2
Serial management interface ports MGMT1 and MGMT2 are available in two DB25 connectors located
on the rear panel.
Data rate available : 9600 bit/s up to 115200 bit/s.
MGMT1 port can be configured in two modes :
- V11 synchronous mode (EIA 530)
- V28 asynchronous mode (ISO 2110)
MGMT1 port can be connected to a modem (RTS, CTS, DTR, DSR and DCD available).
MGMT2 port is not configurable, and is only available in V11 synchronous mode and X24/V11. When it
is used in X24 mode, this interface is a DCE type (terminal mode).
Connector pinout is given in Figure 1.26