TouchChat Express User’s Guide 122
Positioning the Stand
Your device comes with a stand that can be positioned for easy viewing. When closed, the stand is held
in place by a latch.
To position the device at an angle for easy viewing of the screen, do the following:
1. Place the device face-down on a flat surface.
2. While holding your thumb on the edge of the device below the stand’s bottom support, press on the
inside of the support with the tip of your index finger (or the tips of several fingers) to pull the
support away from the latch.
3. Lift the support away from the back of the device until the legs latch into place. Then position the
device.
Removing the Handle
If you do not plan to use the handle, you can remove it by removing the screws that hold it in place.
The handle and screws are potential choking hazards.
To Next Page
