Sam4s ER-180T - Memory Clear; RAM All Clear

ER-180T Electronic Cash Register AU Getting Started • 11
Memory Clear
RAM All Clear
RAM clearing the cash register erases all programming and totals. Use this program the first time the
cash register is programmed.
CAUTION: The procedures described in this area are security sensitive. Clearing all or parts of
the memory may cause damage or loss to the program. Do not share this
information with unauthorized users and distribute the special SERVICE-Mode
key only to those you may want to perform these functions.
Perform "Clear All Totals" if you wish to clear only parts of memory. Complete clearing of all
memory areas and installation of the default program can be done through the following special
procedure:
To Perform a Memory All Clear (reset memory completely):
1. Unplug power adaptor from ECR.
2. Turn the control lock to the S-Mode (The S position is a hidden position one passed P-
position).
3. Press and hold the key position where the CHARGE key (circled one) is located on the
default keyboard layout.
4. Continue to hold the CHARGE key while plug the ECR into a power source.
5. After hear BEEP, release the CHARGE key.
6. Press the upper left button (FEED) of the keyboard, then the lower left button (TAX),
then the upper right button (CALC), and finally press the lower right buton
(CASH/TEND).
CHARGE
6
CHECK
14 10
PO
(-)
5
RA
(+)
13 9
7 15 11
SUB TOTAL
CALC
CLERK
-
NO
SALE
+ % - %
8 16 12
CASH / TEND
(=)
2
VOID
6
5
4
1
RETURN
9
8
7
CA NCE L
2
1
RCPT
ON/OFF
C/ CO NV
FEED
X/TIME
(X)
PLU CLEAR
TAX
00
0
3
4
3
•
7. Display will show “= = = = = = = = = = = =” while proceeding.
8. When memory is cleared, the register prints a message “RAM ALL CLEAR OK!”,
followed by the EPROM information.
④
③
②
①