Sam4s ER-180T - System Option Programming; Program 30 - System Option Programming

64 • Contents ER-180T Electronic Cash Register AU
System Option Programming
Refer to the “System Option Table” to review the system options. Read each option carefully to
determine if you wish to make any changes.
NOTE: Because after clearing memory all options settings are automatically set to 0, and because
your most likely option selections require a status setting of 0, you do not need to program
this section unless you wish to change the default status.
Program 30 - System Option Programming
Programming a System Option:
1. Turn the control lock to the PGM-Mode.
2. Enter 3 0, press the SUBTOTAL key.
3. Enter a system option address, and then press the X/TIME key.
4. Enter the number representing the status you have selected, or if there is more than
one decision to be made in an address, add the values representing your choices for
each decision and enter the sum. Press the SUBTOTAL key.
5. Repeat from step 3 for each system option you wish to change.
6. Press the CASH key to end system option programming.
System Option Flowchart
SBTLX/TIME
Status
CASH
Repeat for each
S
y
stem Option
Option #
SBTL 0 3