ER-180T Electronic Cash Register AU Program Mode Programming • 71
Program 70 - Function Key Options
Use Program 70 to set options for function keys. Because of the differences inherent in function keys,
individual options will be different. See the specific instructions for each key in this chapter to find
the options for each key.
1. Turn the control lock to the PGM-Mode.
2. To begin the program, enter 7 0, press the SUBTOTAL key.
0 SBTL 7
3. Enter the values for the option digit or digits. Depending on the function key you are
programming, you may enter up to six digits N1 through N6. Determine the values for N1
through N6 by referring to the specific function key information that follows. (You do not
need to enter preceding zeros. For example, if the function key offers six digits, N1
through N6 and you are only selecting a value for N6, just enter the value for N6.) Press the
function key you wish to program.
N3 N2 N1 N4 N5
FUNCTION
KEY
N6
4. To program additional function keys, repeat from step 3, or press the CASH key to finalize
the program.
CASH
To Next Page
Loading...
