12 • Contents ER-180T Electronic Cash Register AU
Initial Clear
CAUTION: Do not share this information with unauthorized users. Distribute the C and P
Mode key only to those you may want to perform this function.
The initial clear function allows you to exit any register activity and return to a beginning or
cleared state. Any transaction that is in progress will be exited and totals for that transaction will not
be updated. This procedure will not affect register programming, or clear previously stored totals in
ECR memory
Here are some reasons you may want to perform an initial clear:
• The register is in an unknown state, and you wish to exit the current program or transaction
without following normal procedures.
• You have performed a function that includes a compulsory activity and you wish to bypass
the compulsion.
• An initial clear may be necessary as part of servicing, or troubleshooting..
To Perform an Initial Clear:
1. Unplug power adaptor from ECR.
2. Turn the control lock to the PGM-Mode.
3. Press and hold the key position where the SUBTOTAL key is located on the default
keyboard layout.
4. While continuing to hold the SUBTOTAL key, plug the register into a power source.
5. The message "INITIAL CLEAR OK!” prints when the initial clear is complete.Operating
Instructions
To Next Page
Loading...
