56 • Contents ER-180T Electronic Cash Register AU
Program 500 - Department Status Programming
1. Turn the control lock to the PGM-Mode.
2. To begin the program, enter 5 0 0, press the SUBTOTAL key.
0 SBTL 0 5
3. Select the Department or Departments you wish to program in one of the following ways:
• Press a Department on the keyboard, or
DEPT
• Press the first Department in a range of Departments that are to receive the same
setting then press the last Department.
DEPT DE PT
4. Refer to the "Department Status Chart" to determine the values for N1 through N8. Enter
the values you have selected, press the X/TIME key. (You do not need to enter preceding
zeros.)
N3 N2 N1 N4 N5 X/TIMEN6 N7 N8
5. To program additional Departments, repeat from step 3, or press the CASH key to finalize
the program.
CASH
Department Status Chart
Address Program Option Value
N1
Department is negative item
Yes = 1
No = 0
N2
Department is single item
Yes = 1
No = 0
N3
Department is taxable by rate 4?
Yes = 1
No = 0
N4
Department is taxable by rate 3?
Yes = 1
No = 0
N5
Department is taxable by rate 2?
Yes = 1
No = 0
N6
Department is taxable by rate 1?
Yes = 1
No = 0
N7
Department is override preset?
Yes = 1
No = 0
N8
Department is preset?
Yes = 1
No = 0
AU default 00000111
To Next Page
Loading...
