ER-180T Electronic Cash Register AU Program Mode Programming • 67
Print Option Programming
Refer to the “Print Option Table” to review the print options. Read each option carefully to
determine if you wish to make any changes.
NOTE: Because after clearing memory all options settings are automatically set to 0, and because
your most likely option selections require a status setting of 0, you do not need to program
this section unless you wish to change the default status.
Program 40 - Print Option Programming
Programming a Print Option:
1. Turn the control lock to the PGM-Mode.
2. Enter 4 0, press the SUBTOTAL key.
3. Enter a print option address, and then press the X/TIME key.
4. Enter the number representing the status you have selected, or if there is more than
one decision to be made in an address, add the values representing your choices for
each decision and enter the sum. Press the SUBTOTAL key.
5. Repeat from step 3 for each print option you wish to change.
6. Press the CASH key to end print option programming.
Print Option Flowchart
SBTLX/TIME
Status
CASH
Repeat for each
Print Option
Option #
SBTL 0 4
To Next Page
Loading...
Need help?
General
