Samson 5824 - Additional Equipment

EB 5824-2 EN 3-3
Design and principle of operation
Conguration
TheactuatorisconguredwiththeTROVIS-
VIEW software. In this case, the serial
interface on the actuator is used to connect
the actuator to the computer.
The TROVIS-VIEW software enables the user
toeasilycongurethepositioneraswellas
view process parameters online.
TROVIS-VIEW can be downloaded free of
charge from our website at
uwww.samsongroup.com > SERVICE &
SUPPORT > Downloads > TROVIS-VIEW.
Further information on TROVIS-VIEW (e.g.
system requirements) is available on our
website and in the Data Sheet uT6661 as
well as the Operating Instructions
uEB6661.
Î Seethe'Start-upandconguration'sec-
tion.
3.3 Additional equipment
Limit contacts
Devicesin24Vversioncanbettedwith
limit contacts. The limit contacts consist of
two changeover switches. Their switching
positions are changed independently from
one another by continuously adjustable cam
disks.Theoatingcontactscanbeusedas
eithermakeorbreakcontactstoinuence
the tasks of control equipment.
The adjustment of the limit contacts is de-
scribed in the 'Installation' section.
Note
Itisnotpossibletoretrotlimitcontacts.