Samson 5824 - Shipment and On-Site Transport; Accepting the Delivered Goods; Removing the Packaging from the Actuator; Transporting the Actuator

EB 5824-2 EN 4-1
Shipment and on-site transport
4 Shipment and on-site trans-
port
The work described in this section is only to
be performed by personnel appropriately
qualiedtocarryoutsuchtasks.
4.1 Accepting the delivered
goods
After receiving the shipment, proceed as fol-
lows:
1. Compare the shipment received with the
delivery note.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent (re-
fer to delivery note).
4.2 Removing the packaging
from the actuator
Do not remove the packaging until immedi-
ately before mounting and start-up.
1. Remove the packaging from the electric
actuator.
2. Checkscopeofdelivery(seeFig.4-1).
3. Dispose of the packaging in accordance
with the valid regulations.
1x Type5824orType5825ElectricActuator
1x DocumentIP5824-2
(Important Product Information)
Fig.4-1: Scope of delivery
Note
4.3 Transporting the actuator
− Protect the electric actuator against exter-
nalinuences(e.g.impact).
− Protect the electric actuator against mois-
ture and dirt.
− Observe the permissible transportation
temperatureof–20to+70°C.
4.4 Lifting the actuator
Due to the low service weight, lifting equip-
ment is not required to lift the electric actua-
tor.
4.5 Storing the actuator
Risk of electric actuator damage due to im-
proper storage.
Î Observe the storage instructions.
Î Avoid long storage times.
Î Contact SAMSON in case of different
storage conditions or longer storage
times.
We recommend regularly checking the elec-
tric actuator and the prevailing storage con-
ditions during long storage periods.
NOTICE
!
Note