Samson 5824 - Copying Function; Data Logging

EB 5824-2 EN 8-7
Operation
8.4.1 Copying function
ThememorypencanbeusedtocopysettingdatatootherTypes5824and5825Actuators
after the data from the actuator have been transferred to the memory pen.
“Automatically write to memory pen” is automatically reset to the read status after data are
transferred from the actuator for the rst time.
8.4.2 Data logging
Thememorypen-64allowsthefollowingdatatobesaved:
− Inputin%
− Actuatortravelin%
− Positionfeedbackin%
− Temperatureinsidedevicein°C
− Torqueswitch:Actuatorstemretracted
− Torqueswitch:Actuatorstemextended
− Position feedback is relative
− Malfunctions
− Input signal failure
− Direction of action switch
− Function switch initialization
The data are logged until the memory capacity of the memory pen is full.
DatainthememorypencanbesavedtoadataloggingleusingtheTROVIS-VIEWsoft-
ware.
Note