Samson 5824 - Electrical Connection

5-6 EB 5824-2 EN
Installation
5.6 Electrical connection
Risk of fatal injury due to electric shock.
Î Upon installation of the electric cables,
you are required to observe the regula-
tions concerning low-voltage installations
according to DINVDE0100 as well as
the regulations of your local power sup-
plier.
Î Use a suitable voltage supply which
guarantees that no dangerous voltages
reach the device in normal operation or
in the event of a fault in the system or
any other system parts.
Î Only perform the electrical connection
after switching off the supply voltage.
Make sure the supply voltage cannot be
switched on again unintentionally.
Risk of actuator damage due to incorrect
wiring of the inputs.
Î Wire the inputs range according to the
technical data (see the 'Design and prin-
ciple of operation' section).
Wiring
Î ConnectthewiringasshowninFig.5-5.
Risk of actuator damage due to a short cir-
cuit.
The supply voltage as well as the input and
output signals are not galvanically isolated
from one another.
Î Do not apply any external voltage.
Î Do not connect terminals with each other.
DANGER
!
NOTICE
!
NOTICE
!