Samson 5824 - Command Mode; Readings in TROVIS-VIEW; Operating Values; Operating States

EB 5824-2 EN 8-9
Operation
8.4.3 Command mode
In closed-loop operation, the actuator stem can be moved to the top or bottom end position
using the command pen regardless of the input signal.
Possiblesettings:
− No command
− Retract actuator stem
− Extend the actuator stem
8.5 ReadingsinTROVIS-VIEW
8.5.1 Operating values
The values in the Operating values folder cannot be changed.
In online mode, the current operating values are listed in the 'Operating values' folder. De-
pending on the basic setting, a graph is shown under the 'Operating values' window.
8.5.2 Operating states
Error messages can be read in the 'Service' folder ('Operating states').
Operating states and errors are also indicated by the LEDs (see section8.2).
Note
Note