Samson 5824 - Functions (Service Folder); Functions

16-10 EB 5824-2 EN
16.5.8.2 Functions
Perform reset
The actuator is restarted.
Load default settings in actuator
Thecongurationisresettothedefaultsetting.
Start zero calibration
The actuator moves to the lower end position (stem extended). After the zero calibration is
completed, the transit time is adopted and the actuator is ready for operation. The actuator
stem is moved to the position determined by the input signal.
Start transit time measurement
Measures the time required to move from one end position to the other.