Samson 5824 - Page 50

8-8 EB 5824-2 EN
Operation
Data logging
1. Plugthememorypenintotheserialinterfaceoftheactuator(Fig.8-4).
The yellow LED on the actuator indicates that the data logging is being prepared.
− Preparing data logging
On
Off
Time in s
A change in the blinking pattern of the yellow LED indicates that data are being saved to
the memory pen.
− Data logging in progress
On
Off
Time in s
2. Data logging is completed when you remove the memory pen from the serial interface of
the actuator.
You can load a data logging le into the Trend-Viewer by selecting Load diagram ... from the
context-sensitive menu.
Transferring data onto a computer
1. Insert the memory pen together with modular adapter into the serial interface (COM
port) of the computer (see Annex for accessories).
2. Select 'Read Logged Data' from the 'Memory Pen' menu.
3. Select the desired target directory. If the target directory is not changed, data will be
savedintheSAMSONfolder>Type5824.
4. Enterthelename.
5. Click 'Save' to start data transmission.
Note