Disclaimer of liability
We are constantly developing our products and therefore, reserve the right to change the
product or the information contained in this document at any time without notice.
We do not assume any liability for the accuracy or completeness of these mounting and op-
erating instructions. Moreover, we do not guarantee that the buyer can use the product for
an intended purpose. SAMSON rejects any liability for claims by the buyer, especially
claims for compensation including lost profits or any other financial loss, except the damage
was caused intentionally or by gross negligence. If an essential term of the contract is
breached by negligence, SAMSON’s liability is limited to the foreseeable damage.
Safety instructions
4
The device may only be assembled, started up or operated by trained and
experienced personnel familiar with the product. Proper shipping and ap-
propriate storage are assumed.
4
The controller has been designed for use in electrical power systems. For
wiring and maintenance, you are required to observe the relevant safety
regulations.
2 EB 5579 EN
Disclaimer of liability
Modifications to controller firmware in comparison to previous versions
1.70
(previous)
1.71 (new)
Err 2 message (default setting loaded) is not displayed anymore. See section 8.1.
Single error messages to be forwarded over the device bus and an automatic call to the
building control system in the event of a fault in modem operation can be selected. See
section 7.12.6 and 8.5.
1.71
(previous)
1.82 (new)
An interrupted drying of jointless floors can be continued by selecting the restarting stages
START temperature maintaining phase
or
START temperature reduction phase
. See section
5.3.
During thermal disinfection, the
Hold time of disinfection temperature
can be used to deter-
mine how long the disinfection temperature must be maintained within the adjusted time
period to rate the process successful. See section 6.10.
Besides the release of single control circuits, the release of the controller is possible over
the binary input. See section 7.9.
To Next Page
Loading...
