Samson TROVIS 5579 - Setting the Party Mode

1.7 Setting the party mode
Using the Party mode function, the controller continues or activates the rated operation of
the controller during the time when the party timer is active, regardless of the programmed
times-of-use. The party timer begins when the rotary switch has been returned to operating
mode “Automatic“. When the party timer has elapsed, the party timer is reset to 00:00.
The party modes for the different control circuits are set at the rotary switches one after the
other:
Party timer Rotary switch Position
Heating circuit 1* Top
Heating circuit 2* Middle
DHW heating/heating circuit 3* Bottom
* Refer to page 161 for assignment
Parameter
WE Range of values
Continue/activate rated operation 0 h 0 to 48 hours
Proceed as follows:
Turn appropriate rotary switch to “Party mode“.
Display shows:
00:00 or the remaining time of the party timer
q
Edit desired length of the one-off time-of-use.
Return the rotary switch to operating mode “Automatic“ (left side).
Note: Elapsing of the party timer is displayed in steps of 15 minutes.
EB 5579 EN 15
Operation