TEMI 880
Hot: after power off, restore to the segment which is current running when the
power off, or the SV of Fix Mode. And test is auto-running.
4 Fuzzy select: control over shoot by fuzzy select.
8.2.Fix Set
Click on the “FIX SET”’s pattern in Figure 19 to enter Fix Set screen.
Fix Set Screen
Figure 23
1 Run time: See 8.1 Mode Set
2 Temp & Press slope: setting FIX Mode temp/press slope. And their PV goes
to SP gradually both up and down, according to the slope setting value.
See 8.2.1 Slope Operation
► Slope function is available on FIX Mode only.
► Run Time (8.1 “
②
” & 8.2 “
①
”) of FIX Mode.
Setting running time, FIX Mode test will stop after finished running time
automatically. If not, then FIX Mode test will stop by manually or power off.
To Next Page
Loading...