Samwontech TEMI 880 - Program Repeat Explanation; Other Program Settings

TEMI 880
43
11.2. Loop Set
Click on the “CYCLE” column in Figure 47 or “LOOP SET” in Figure 49 to enter
Loop Set screen as Figure 53.
Loop Set Screen
Figure 53
① is Segment cycle (segments in the same Program):
Start: setting the segment cycle’s beginning segment number.
End: setting the segment cycle’s ending segment number.
Count: setting the segment cycle counts.
See 11.2.1 Segment Repeat Explanation
② is Program cycle:
Prog. cycle: setting the cycle program number.
Link to NO. after cycle: setting next link NO. after last cycle program.
See 11.2.2 Program Repeat Explanation
②
①