TEMI 880
8 No magnetic disturbances are caused.
9 No wind blows against the terminal board. Also no dust or salt content.
10 No flammable materials are around.
1.4.Install Notice
1 There is little influence for electromagnetic fields and noise.
2 No moisture can get into the system.
3 Ambient temp. and Pressure : 10~50℃, 20~90%RH. (At non-freezing status).
Storage temp. and Pressure : -25~70℃, 5~95%RH. (At non-freezing status).
4 If you want to use it after keeping it under 0℃, you need to warm it up for 2
hours at room temperature before plugging it in and warm it up for 30 minutes
after plugging it in. Otherwise, it may not function normally and the product
may be damaged.
5 Do not use around any machine, which heat up. Avoid installing it with the
front facing slant.
6 Transient over voltage category is categoryⅡ. Applicable rated pollution
degree is pollution degreeⅡ.
7 Before starting wiring, be sure to turn off the system or else you will get an
electrical shock.
8 Install the guard panel under the controllers for your safety and installation
with easy.
9 The I/O relay board must be installed inside of Temp. & Press. Chamber.
10 The I/O relay board must be tied up with 4 pieces of bolt and nut at the 4 holes
on the I/O relay board.
To Next Page
Loading...
Need help?
General