Sanremo Opera - Page 30

06-2017
10 / 12
OPERA
CAP. 4
Installation and connection
EN
Fig. 9
I
12
4
9
10
8
7
11
11
A
• Position a jug with handle under dispenser (10) and
dispense water by pressing button (9), checking
that dispensing is correct; water dispensing will stop
automatically at the end of the set time.
• Position a jug of water and insert the tap (8) into it.
Open the steam tap by turning lever (7) to the vertical
or horizontal position (360° opening) and try to heat
water up.
Repeat the same operation with the other dispenser
on the other side of the machine.
• Assemblethelterholders(11)intheunits,position
the cups under them and dispense by pressing the
top lever (4) of each unit, enabling the three settings
by means of the relevant buttons (12).
Check proper dispensing of water into the cup.
IMPORTANT
Move the lever (4) forward “A” to dispense
for two coffee; move lever (4) backward “I”
to dispense for one coffees.
ATTENTION
We recommend the following maximum
quantities of the
dispense:
• maximum 100 cc continuous dispens-
ing coffee for each coffee unit
• maximum 500cc of hot water in contin-
uous dispensing
• 30 seconds of a continuous dispensing
steam.