Sanremo Opera - Page 9

06-2017
CAP. 1
3 / 4
OPERA
General warnings and regulations
by good technical practice, in accordance
with current regulations and complying with
workplace health and safety standard as set
out by current laws of the country where the
machine is used.
- The manufacturer will not be held liable
for any accident or damage to persons
or things arising from failure to observe
safety standards and instructions of this
manual.
Any use other than the use described
in this manual must be considered as
improper use; if you believe this manual
is not sufciently clear for your needs,
always contact the local dealership or
the manufacturer to receive further in-
structions and solutions.
- THESE SAFETY STANDARDS COM-
PLETE OR EXCEED CURRENT LOCAL
SAFETY REGULATIONS.
- IF IN DOUBT, ALWAYS REQUIRE THE
INTERVENTION OF SPECIALIZED PER-
SONNEL.
- ANY ELECTRICAL/ELECTRONIC OR
MECHANICAL TAMPERING WITH THE
MACHINE BY THE USER AND NEG-
LIGENT USE OF THE MACHINE WILL
WAIVE ANY LIABILITY FOR THE MAN-
UFACTURER, MAKING THE USER THE
ONLY ONE RESPONSIBLE BEFORE
INJURY PREVENTION AUTHORITIES.
1.2 - STANDARD REFERENCES
- The machine and its safety devices have
been manufactured in compliance with the
standards listed under the declaration of
conformity.
1.3 - DESCRIPTION OF SYMBOLS
Many accidents are caused by insufcient
knowledge and failure to apply safety rules
during operation and maintenance of the
machine.
In order to avoid accidents, read, under-
stand and follow all cautions and warnings
contained in this manual and those shown on
the labels applied to the machine.
To identify the safety messages included in
this manual the following symbols have been
used:
HAZARD
This symbol is used in the safety messag-
es of the manual, when potential danger
situations exist or there is a likelihood of
causing serious injury or death.
ATTENTION
This symbol is used in the safety messag-
es of the manual, when danger may cause
minor or moderate injury or damage if not
attended to.
This message can be used also only for
danger that may cause damage to the
machine.
IMPORTANT
This symbol is used for precautions to be
taken to avoid operations that may short-
en the life of the machine or for important
communications to the operator.
These operations must be performed by
a specialised and authorised technician.