TUNABLE LD LIGHT SOURCE TSL-210
5-1
5
Safety Notes and Safety Devices
When the unit is not in operation, be sure to disconnect the power cord.
In the event of any of the following, make sure that the injection current of the LD is zero, turn
OFF the main switch and then disconnect the power cord.
• Spilling liquid into this product
• Rain getting into this product, or excessive humidity
• Cleaning or moving the product
• Damage or scratch found on the cord or plug of this product.
• Dew or other moisture accumulation.
Please follow the following safety guidelines :
• Avoid impact or shock.
• Keep this product away from water.
• Do not disassemble this product.
• Do not place anything on this product.
• Do not block the ventilation hole or impede the operation of the fan in any manner.
• Avoid placing this product under direct sunlight.
• Avoid placing this product in a place subject to noise by electric field, magnetic field, etc.
• Avoid placing this product in a place subject to high temperature and high humidity.
CAUTION
IMPORTANT! Please read the following for your safety and for trouble-free operation.
Protective shutter
Optical output
DANGER!!
This product employs a semiconductor laser. The laser beam may cause damage to
your sense of sight if it comes in contact with your eyes. It is very dangerous.
Therefore, pay sufficient attention to handling it. When not using the unit, be sure to
close the protective shutter (shown in the figure below).
Do not open the instrument case. The laser beam used in this product is harmful to
the eyes. There are no user servicable parts. Please refer all maintenance and repair
to a Santec engineer.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
