Sanyo PLC-XE33

69
Checktheindicatorsforprojectorcondition.
•••green. •••red •••off
•••blinksgreen.
Whentheprojectionlampreachesitsendoflife,theLAMPREPLACEindicatorlightsyellow.Whenthisindicator
lightsyellow,replacetheprojectionlampwithanewonepromptly.(pp.55,61)
Theprojectorisoff.(TheACpowercordisunplugged.)
Theprojectorisinstand-bymode.PresstheON/STAND-BYbutton
toturnontheprojector.
Projector Condition
POWER
red/green
Indicators
LAMP
REPLACE
yellow
WARNING
red

Theprojectorispreparingforstand-byortheprojectionlampis
beingcooleddown.Theprojectorcannotbeturnedonuntilcooling
iscompletedandthePOWERindicatorstopsblinking.

Thetemperatureinsidetheprojectorisabnormallyhigh.The
projectorcannotbeturnedon.Whentheprojectoriscooleddown
enoughandthetemperaturereturnstonormal,thePOWER
indicatorstopsblinkingandtheprojectorcanbeturnedon.(The
WARNINGindicatorkeepsblinking.)

Theprojectordetectsanabnormalconditionandcannotbeturned
on.UnplugtheACpowercordandplugitagaintoturnonthe
projector.Iftheprojectoristurnedoffagain,unplugtheACpower
cordandcontactthedealerortheservicecenterforserviceand
checkup.Donotleavetheprojectoron.Itmaycauseanelectric
shockorafirehazard.

Theprojectorisoperatingnormally.

TheprojectorisinthePowermanagementmode.


Theprojectorhasbeencooleddownenoughandthetemperature
returnstonormal.Whenturningontheprojector,theWARNING
indicatorstopsblinking.
Indicators and Projector Condition
•••blinksred.
Appendix
Downloaded From projector-manual.com Sanyo Manuals