Sanyo PLC-XE33

37
Video Input
ChooseComputer 1(Component)orComputer 1(Scart) bypressingtheCOMPONENTortheCOMPUTER1
buttonontheremotecontrol.
Beforeusingthesebuttons,correctinputsourceshouldbeselectedthroughMenuoperationasdescribed
below.
1
Input Menu
2
UsethePoint▲▼buttonstoselectComputer 1and
thenpressthePoint►button.
Input Source Selection (Component, RGB Scart 21-pin)
Whentheinputsourceiscomingfromvideo
equipmentconnectedtotheCOMPUTER
IN1/S-VIDEOIN/COMPONENTINterminal
withaComponent-VGACable,select
Component.
Component
Whentheinputsourceiscomingfromvideo
equipmentconnectedtotheCOMPUTER
IN1/S-VIDEOIN/COMPONENTINterminal
withaScart-VGACable,selectRGB
(Scart).
RGB (Scart)
Direct Operation
Menu Operation
PresstheMENUbuttontodisplaytheOn-Screen
Menu.UsethePoint▲▼buttonstoselectInputand
thenpressthePoint►ortheSELECTbutton.
Note:

  WhentheInputSearchfunctionissettoOn1orOn2,
theinputsignalwillbesearchedautomatically(p.44).
COMPUTER 1 button
Remote Control
3
UsethePoint▲▼buttonstoselectComponentor
RGB(Scart)andthenpresstheSELECTbutton.
Computer 1(RGB)
Computer 1(Scart)
COMPONENT button
Computer 1(Component)
Downloaded From projector-manual.com Sanyo Manuals