EasyManua.ls Logo

Sanyo PLC-XE33 - Maintenance and Cleaning; WARNING Indicator and Projector Condition

Sanyo PLC-XE33
77 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
58
TheWARNINGindicatorshowsthestateofthefunctionwhichprotectstheprojector.Checkthestateofthe
WARNINGindicatorandthePOWERindicatortotakepropermaintenance.
WARNING indicator
The projector is shut down and the WARNING
indicator is blinking red.
Whenthetemperatureinsidetheprojectorreachesa
certainlevel,theprojectorwillbeautomaticallyshutdownto
protecttheinsideoftheprojector.ThePOWERindicatoris
blinkingwhiletheprojectorisbeingcooleddown.Whenthe
projectorhascooleddownenough(toitsnormaloperating
temperature),itcanbeturnedonagainbypressingtheON/
STAND-BYbutton.
The projector is shut down and the WARNING
indicator lights red.
Whentheprojectordetectsanabnormalcondition,itis
automaticallyshutdowntoprotecttheinsideoftheprojector
andtheWARNINGindicatorlightsred.Inthiscase,unplug
theACpowercordandreconnectit,andthenturnthe
projectorononceagaintoverifyoperation.Iftheprojector
cannotbeturnedonandtheWARNINGindicatorstilllights
red,unplugtheACpowercordandcontacttheservice
station.
CAUTION
DONOTLEAVETHEPROJECTORWITHTHE
ACPOWERCORDCONNECTEDUNDERAN
ABNORMALCONDITION.ITMAYRESULTIN
FIREORELECTRICSHOCK.
Maintenance and Cleaning
Top Control
Top Control
Note:
TheWARNINGindicatorcontinuestoblinkevenafter
thetemperatureinsidetheprojectorreturnstonormal.
Whentheprojectoristurnedonagain,theWARNING
indicatorstopsblinking.
Then check the matters below:
–Didyouprovideappropriatespacefortheprojectortobe
ventilated?Checktheinstallingconditiontoseeiftheair
ventsoftheprojectorarenotblocked.
–HastheprojectorbeeninstallednearanAir-Conditioning/
HeatingDuctorVent?Movetheinstallationofthe
projectorawayfromtheductorvent.
–Isthefilterclean?Cleanthefilterperiodically.
WARNING blinking
red
WARNINGlights
red
Downloaded From projector-manual.com Sanyo Manuals

Table of Contents

Other manuals for Sanyo PLC-XE33

Related product manuals