Sanyo PLC XU115 - XGA LCD Projector

64
Appendix
No image –Checktheconnectionbetweenyourcomputerorvideoequipment
   andtheprojector.Seepages19-21.
  –Seeiftheinputsignaliscorrectlyoutputfromyourcomputer.Some
   laptopcomputersmayneedtochangethesettingformonitoroutput
  whenconnectingtoaprojector.Seeyourcomputer’sinstruction
   manualforthesetting.
  –Ittakesabout30secondstodisplayanimageafterturningonthe
   projector.Seepage22.
  –ChecktheInputsignal,colorsystem,videosystemorcomputer
systemmode.
  –MakesurethetemperatureisnotoutofthespecifiedOperating
   Temperature(41˚F–95˚F[5˚C–35˚C]).
  –When"NoShow"isoperating,theimagecannotbedisplayed.Press
   theNOSHOWbuttonoranyotherbuttonontheremotecontrol.
No sound –Checktheaudiocableconnectionfromaudioinputsource.
  –Adjusttheaudiosource.
  –PresstheVolume+button.Seepage27.
  –PresstheMutebutton.Seepage27.
 –WhentheAUDIOOUTisplugged-in,theprojector'sbuilt-inspeaker
   isnotavailable      
  –Istheimageprojected?Youwillhearthesoundonlywhentheimage
 isprojected.
The color is strange. –ChecktheInputsignal,colorsystem,videosystemorcomputer
   systemmode.      
  –Makesurethe"Blackboard"isnotselectedonImageselect 
   menu.(seepage36,43)
Some displays are not seen –ChecktheDisplayfunction.Seepage48.
during the operation.
Auto PC adjustment function –ChecktheInputsignal.AutoPCfunctioncannotworkwhen 
does not work.  480p,575p.720p,480i,575i,1035ior1080iisselectedorwhenthe
   digitalsignalisinputintoDVIterminal.(seePage34)
  –Theiconisnotavailableingrayoutwhenthedigitalsignalisinput.
The setting does not remain  –Makesureyouselected"Store"afteradjustingsetting.Somesettings
after turning off power.  cannotbestoredifnotregisteredwith"Store".(seepage45)
Power management does –Powermanagementfunctioncannotworkwhile"Freeze"or"No
work.  Show"functionisrunning.(seepage52)
Capture function does not work. –Checktheconnectionandtheinputsignaltoseeifthereissignal.
Auto setup does not work properly. –Makesure"Off"isnotselectedattheAutosetupfunction.(seepage
   47)
  –Makesure"On"isnotselectedattheCeilingfunction.(seepage51)
Auto keystone function does not  –MakesuretheAutokeystonefunctionisnotsetto"Manual".Press
work even when the projector is theAUTOSETUPbuttononthetopcontrol.(seepage26,47) 
tipped.