Sanyo VPC-MZ2EX - Page 184

TROUBLESHOOTING
Problem Cause Action
Reference
page
Power
While the flash
is recharging,
the LCD monitor
suddenly turns
off.
Battery power is
low, activating the
function that
momentarily turns
off the LCD
monitor.
Not a malfunction.
When the flash is
fully charged, the
LCD monitor will
turn on again.
72
Shooting
An image is not
captured when
the shutter
release button is
pressed.
The power is not
turned on.
If the power save
function has turned
the digital camera
off, then press the
MODE button,
power button, or
press once on the
shutter release
button to turn the
digital camera back
on.
38
The standby
indicator is flashing
red (the digital
camera is not yet
ready to capture an
image).
Wait until the
standby indicator
lights green to
capture the image.
—
The memory is full
(the standby
indicator lights red,
the displayed
remaining number
of images that can
be captured
becomes [0] on the
LCD monitor).
Install a new card.
26
Erase the images
that are not
necessary.
Save the images to
separate media,
then erase all the
images from the
card.
157, 162
SX215/EX, U (VPC-MZ2 GB) Mon. March 25/2002
English
181