Output of “wRef” and “nRef”
Automatic output of the average piece weight, “wRef,” and the reference sample
quantity, “nRef”:
Your scale calculates the average piece weight from the number of parts loaded
and the weight of the pieces; the calculation begins when you press the u/w
key. This value can be output to a printer, depending on the code setting selected.
Output of “wRef” and “nRef” Code Changes
No output 7 6 1
Reference sample quantity “nRef”762
Average piece weight “wRef”763
Piece count “nRef” and piece weight “wRef”764*
Output of Net-/Tare-/Gross Weights/Counting Result
Depending on the settings for tare memory and the counting application,
the following data can be output to an on-line printer.
Output Code Changes
Output net weight or counting result 7 7 1
Output net weight and piece count 7 7 2
Output net weight/tare compensation/
gross weight or counting result 7 7 3
Output net weight/tare compensation/
gross weight and counting result 7 7 4 *
Line Feed
You can configure your printer to add a line feed automatically at the end
of a printout (1to 3 lines). This means you can tear off the printout as soon as it is
output, without having to press the line feed key on your printer.
Line feed Code Changes
No line feed 7 8 1
Line feed – 1 line 7 8 2
Line feed – 2 lines 7 8 3
Line feed – 3 lines 7 8 4 *
*= factory setting
2–15
To Next Page
Loading...
Need help?
General