Step/Key Display Data Output
Enter the tolerance
values (e.g.1g) using
the numeric keys 1 .
0 g
1.0 g
Press the z/T key again +
100.1 g
An acoustic signal is given
(beep tone) and the data output
is generated automatically. Setp + 100.1 g
d-min - 1.0 g
d-max + 1.0 g
LL
Place the next package
on the scale +
100.1 g
N + 100.1 g
GOOD values are
output automatically
If the package is too heavy,
this is indicated by HH HH
in the display. If the weight
value is in the GOOD range,
output is generated
automatically and an acoustic
signal is given.
Note:
A number entered manually without a decimal point is always a piece count!
A number entered manually with a decimal point is always a weight value!
3–25
To Next Page
Loading...
Need help?
General