8 PM135 Powermeter Series
2. Configuring the PM135 remotely
1. Install the PAS application software on your PC.
2. Configure the PAS database for your meter.
3. Configure the PAS communications settings.
4. Upgrade the meter firmware if a new version is
available.
5. Set up the meter using the PAS application software.
6. Configure your security settings through the meter
security setup.
7. Configure your communication protocol settings.
8. Configure Billing/TOU registers.
At this stage, the PM135 should be ready for operation.
To Next Page
Loading...
Need help?
General
