Satec PM135EH User Manual

Chapter 6 Device Control and Upgrading Resetting Accumulators, Maximum Values and Files
114 PM135 Powermeter Series
Chapter 6 Device Control and Upgrading
This section describes operations on the meter you can perform from the
front display or via PAS. To access device control options from PAS, you
should have your meter online.
6.1 Resetting Accumulators, Maximum Values and Files
Using the Front Display
Select the RESET entry from the Device Setup menu. See Viewing and
Changing Setup Options in Chapter 3 for information on configuring
parameters via the front display.
To reset the desired values:
1. Select the desired parameter to be
cleared using the UP/DOWN button
then press the ENTER button.
2. Press the ENTER button for
approximately 5 sec until the "Do"
notification is changed to "Done"
Table 20 shows the reset options available from the front display.
Table 20: Front Display Reset Options
Display Label
Description
Volt/Ampere Demands
Clears ampere and volt maximum demands
Power Demands
Clears power maximum demands
All Demands
Clears all maximum demands
Min/Max
Clears Min/Max log
Energy
Clears all total energies
Counters
Clears all counters
Counter 1
Clears counter #1
Counter 2
Clears counter #2
Counter 3
Clears counter #3
Counter 4
Clears counter #4
Diagnostics
Clears device diagnostics
Using PAS
Ensure that the On-line button on the PAS toolbar is checked, and then
select Reset from the Monitor menu.

Satec PM135EH Specifications

General

Brand	Satec
Model	PM135EH
Category	Measuring Instruments
Language	English