Section 5. Configuration Commands
Page 5-8 PN 9001106 Rev. A SATO CX400
Sensor Select
Command Structure
<ESC>CIa
a = 0 Sensor not used
1 Reflective (Eye Mark) sensor
2 See-thru (transmissive) sensor
Example: See above
Placement: Separate data stream sent to printer
Default: See-thru sensor
Command Function
To select the label sensing method for a job.
Input to Printer
<ESC>A
<ESCI1
<ESC>Z
Printer Output
There is no printer output as a result of this command
Special Notes
1. This setting is stored in non-volatile memory. The setting will not
change until another valid <ESC>CIa command is received, even if
power is removed from the printer.
2. The reflective Eye-Mark, label gap or notch must be at leas 2 mm
wide and extend 10 mm from the left edge (facing the printer) of the
label backing.
To Next Page
Loading...
