Section 5. Configuration Commands
Page 5-2 PN 9001106 Rev. A SATO CX400
Backfeed Enable
COMMAND STRUCTURE <ESC>CEa
a = 0 = Disables Backfeed
1 = Enables Backfeed
Example: <ESC>CE1
Placement: Separate data stream sent to printer
Default: Last setting
COMMAND FUNCTION To enable/disable backfeed before printingto align first print line on a
label after it has been dispensed.
INPUT TO PRINTER <ESC>A
<ESC>CE1
<ESC>Z
PRINTER OUTPUT There is no output as a result of this command.
SPECIAL NOTES 1. When Backfeed is enabled, the printer will feed the last label of a
print job forward to the dispense/cut position. Upon receipt of the
next print job, it will retract the label to the first print line position
before printing.
2. This setting is saved in non-volatile memory.
3. The setting becomes ineffective once a cutter or dispenser is
enabled.
To Next Page
Loading...
