SATO CX400 - Journal Print

Section 2: Command Codes
Page 2-38 PN 9001106 Rev. A SATO CX400
Journal Print
Command Structure <ESC>J
Example:
See above
Placement:
Immediately following <ESC>A
Default:
None
Command Function To print text in a line by line format on a label. By specifying this
command, you automatically select Font XS with a Character
Expansion of 2x2. You also establish a base reference point of H2,V2.
The character pitch is 2 dots and the line gap is 16 dots. Simply issue
an ASCII <CR> at the end of each text line.
Input to Printer <ESC>A
<ESC>J WITH THE JOURNAL FEATURE
YOU CAN PRINT TEXT WITHOUT
USING ANY FONT COMMANDS
OR POSITION COMMANDS
<ESC>Q1<ESC>Z
Printer Output
Special Notes 1. Journal mode assumes a maximum label width . Otherwise, you
may print where there is no label and damage your print head.
2. It is effective only for the current print job.
1. The <ESC>A3 Base Reference Point command cannot be used to
change the margins.