Section1. Programming Concepts
Page 1-8 PN 9001106 Rev. A SATO
CX400
<ESC>A<ESC>%1<ESC>V800<ESC>H200<ESC>L0202<ESC>XB1E<ESC>Q1<ESC>Z
COMMAND DEFAULT SETTINGS
There are some types of commands that must have a value specified before a label can be
printed. If the data stream does not contain these commands, a default value is assumed. The
commands and the corresponding default values are:
NOTES:
1. The settings for these commands will revert to the default value when the printer receives
an <ESC>Z or an <ESC>*.
COMMAND DEFAULT NOTE
Print Rotation 0° (1)
Vertical Reference Point 0 (1)
Horizontal Reference Point 0 (1)
Character Pitch 2 (1)
Base Reference Point H=0, V=0 (2)
Character Expansion 1 (1)
Print Darkness 200 (1)
Print Speed 3 ips (2)
To Next Page
Loading...
